Shooting the Russian 7.62×54

Hungarian 7.62x54 Mosin Nagant rifle with original boxed cartridges.

Over the years we have seen a steady progression in rifle performance, and the modernization of rifle powder. Black powder rusted the metal almost as soon as it was fired. Modern rifle powder, such as Varget, is very clean. Corrosive primed ammunition isn’t something to be avoided, and the powder burn is often clean. You simply have to follow a few steps to fire and use this affordable ammunition. Ammunition is declared surplus when no longer needed. There are not a lot of nations still using the 7.62x54R rifle, although it is still in use in heavy machineguns. Some simply need a little cash, and we benefit from the decision. Much of this ammunition was intended for military use and manufactured under stringent control. In my experience, match grade accuracy was not as important as ignition reliability. Since the 7.62×54 Russian is also a machinegun round, the cartridges usually feature a tight crimp. In fact, it is difficult to pull a bullet even with a Kinetic bullet puller.

Hungarian 7.62x54 Mosin Nagant rifle with original boxed cartridges.
The availability of surplus ammunition has made firing and using older rifles less inexpensive and more satisfying.
The availability of surplus ammunition has made firing and using older rifles less inexpensive and more satisfying.

The primer seal is good, and the cartridges often feature a good case mouth seal—normally sealed with some form of lacquer. In other words, this is the type of ammunition you may wish to put into long-term storage. When sealed in a protective can, the ammunition is all the more secure. Of course, I fire and enjoy my surplus ammunition. I simply follow simple steps in cleaning the rifle afterward.

Sale ends July 21, 2019

Sale ends July 21, 2019

Often the surplus ammunition may be properly considered as ammunition put up in a time capsule from an era when prices were lower. Lets look at 7.62×54 ball ammunition. You can fire a good batch of this ammunition on a single trip to the range. The rifles are accurate, fun to shoot and trouble free. Recoil is modest for the power involved. However, the heavier ball loads often strike high at the ranges in which we often practice. The 180-gr. ball load is a bit difficult to sight in at 100 yards.

The 150-grain Hungarian loading at 2800 fps is usually closer to the point of aim at 50 to 100 yards. A 150-grain bullet at 2800 fps is awfully close to the .30-06 Springfield and offers similar performance. If you do not handload, this affordable ammunition is among the best bet on the planet for shooting the Mosin Nagant and shooting it a lot. Accuracy is acceptable, but it really depends upon the rifle.

There are means of tightening up the stock and furniture on the rifle and also making certain the bore is free of copper deposits. While some rifles are more accurate than others, most may be counted on for a three-shot group of 2.5 inches at 100 yards. Often the same rifle will carry to 200 yards and give a four- to five-inch group. That is pretty good for an old war horse. Now, an old rifle that rattles when shook and has been beat up in the war—or wars—might do five inches at 100 yards! On the other hand, one of the Finnish Nagants, with the nicest trigger I have ever experienced on this type of rifle, turned in a lovely 1.25-inch group—the equal of any WW2 era bolt gun. For meaningful practice the inexpensive Hungarian ball works just fine.

Mosin Nagant rifle bolt next to a bottle of glass cleaner.
Cleaning procedure is simple as long as certain procedure is followed.
Corrosive primed ammunition doesn’t rust of its own accord, and the corrosive priming compounds do not rust the barrel on their own. They were used for many years because the composition is stable and reliable in all climatic conditions. The adoption of self-loading rifles pretty much spelled the end of this type of priming. Gas systems would be wrecked by corrosion.

The key elements in corrosive primers are potassium chloride and sodium chloride. When deposited in the barrel and action, they draw moisture and this causes corrosion. After firing these cartridges be certain to thoroughly clean the bore, the bolt and the operating systems.

If you do not clean your modern rifle, you do not need an older rifle and surplus loads… If you are used to using black powder firearms, surplus ammunition gives you a much easier chore. The firearm must be field stripped. I used a spray bottle with ammonia. This really gets to the chemicals and cleans the rifle well. Hot boiling water is OK as well. Be certain the bore is cleaned properly and use a good quality solvent. The rules are little different than cleaning with any other ammunition just be certain to clean the bolt, and the barrel, with ammonia. And as I said, hot water will work well and quickly evaporates. Follow with a light coat of oil, and you are good to go.

As for the Hungarian ammunition, I have enjoyed the modest quantities I have fired, and you will as well.

What has your experience been with the 7.62×54 round? Tell us in the comment section.


The Mission of Cheaper Than Dirt!'s blog. "The Shooter's Log", is to provide information - not opinions - to our customers and the shooting community. We want you, our readers, to be able to make informed decicions. The information provided here does not represent the views of Cheaper Than Dirt!

Comments (33)

  1. Try a spam can that YOU opened, not leftovers that could have been out in the open and exposed for a decade.

    I don’t know if the surplus is filthy or the cosmolene is still leaching out on the inside, but the only way I found to clean it in a reasonable time is to clean it like it’s a black powder rifle with HOT water and soap.
    I got 2 cases (4 sealed spam cans) of Mosin rounds put away for SHTF.

Your email address will not be published. Required fields are marked *

Time limit exceeded. Please click the reload button and complete the captcha once again.

Your discussions, feedback and comments are welcome here as long as they are relevant and insightful. Please be respectful of others. We reserve the right to edit as appropriate, delete profane, harassing, abusive and spam comments or posts, and block repeat offenders. All comments are held for moderation and will appear after approval.